VIDEO. How to make 100W Led Flashlight


RouTe - 09 January 2018, 21:13


Step 1: Housing and Parts

VIDEO. How to make 100W Led Flashlight

To make this light you will need:



Step 2: Mounting the Led

VIDEO. How to make 100W Led Flashlight

Mount the led on a heat sink using thermal paste.
Glue the reflector and led lens on the led with epoxy glue.
Solder wires on the led that will go to the led driver.

Advice: If your heat sink is not big enough you can add active cooling with a fan. Connect the fan directly to the battery source after the on/off switch.

Step 3: Led Driver

VIDEO. How to make 100W Led Flashlight

Choose a Led step up DC DC driver that can hold at least 100W of power.

If you want to have a dimmer option than use the attached photo to make the driver dimmable.
After you upgrade it. Make sure you set up the maximum voltage on the trimmer. The maximum voltage must be as specified by the led chip supplier. Also! note that the led chip may drain more than 100W at the maximum voltage. So check the current too. And Set the maximum voltage a bit lower if needed so you do not exceed 100W at fully opened dimmer and fully charged battery.
Or, eventually you can also choose a constant current driver and set up the current.

Connect the driver's input to the battery after the on/off switch. And the output directly to the LED chip.

Step 4: Fit Inn, Connect

VIDEO. How to make 100W Led Flashlight

Fit the driver in the tube or your own designed housing.
Leave some space for the battery.
Mount the dimmer potentiometer.
Add an on/off switch to the housing and connect it in series with the battery's positive source wire.

Advice: Since lithium batteries must not be discharged under around 3V per cell. Add an lipo checker buzzer inside the tube so it will buzz a sound when your battery is empty. Choose the 2 wire 4S one and connect it after the on/off switch. You can find those online cheap.

Step 5: Finish

VIDEO. How to make 100W Led Flashlight

Fit the battery in the tube, close the tube or your custom housing with 3d printed covers.
That's all. Some more assembly details are in the introduction video.



instructables.com